Hygrometer fit issue
The humidor I have has a hole in the front, below the lid, to hold the hygrometer so that the face of the hygro is flush with the outside of the wood.
I recently replaced the analog hygro with a digital and I'm having problems getting a tight fit on the front of the humidor. The analog came with a rubber ring that ensured it fit properly. The digital did not and on its own is too small to fit properly. The rubber ring combined with the digital won't fit as it's too big.
So, I'm left with either sanding out the hole in the humidor (not sure if that's even a good idea), trying to somehow reshape the rubber ring, or leaving the analog in the hole in the front and then tossing the digital into the humi.
I'm not sure how I should proceed, any suggestions appreciated.
Thanks
Comments